Weber Saint-Gobain - Official website of the company

weber.cote Brush Coat

weber.cote Brush Coat

weber.cote Brush Coat
weber.cote Brush Coat

Product benefits

  • Waterproofs.
  • Integrally coloured for low maintenance.
  • Single coat application.
  • Available in a range of colours.
  • Quality assured raw materials.
  • Exceptional and consistent quality.
  • Backed by superior technical support.

weber.cote Brush Coat is a cement based, coloured, waterproof, textured finish for interior and exterior walls applied by block brush. Produced from carefully selected raw materials for consistency of product, it only requires the addition of water on site.

Product Features

Use

Provides a durable, coloured, waterproof coating for brick/block work in one coat.

Suitable surfaces:

Flush brick-work or block-work and scratched cement plasters. Not suitable for previously painted surfaces.

Features and Benefits

  • Waterproofs.
  • Integrally coloured for low maintenance.
  • Single coat application.
  • Available in a range of colours.
  • Quality assured raw materials.
  • Exceptional and consistent quality.
  • Backed by superior technical support.

Storage

When stored, unopened in a dry place at temperatures above 5ºC, shelf life is 12 months from date of manufacture.

Documentation

Send or download the documentation

You can either send the documentation to an email address, or download it.

Preparation & Application

Surface Preparation

The surface onto which weber.cote Brush Coat will be applied:

  • Must be cured for a minimum of 28 days.
  • Must be sound, clean and free of any material which may impair adhesion.
  • Must be true in plane, hard and slightly rough to form a mechanical key.

Mixing

  • Combine 3 volumes of weber.cote Brush Coat with 1 volume of water.
  • Stir thoroughly.
  • A small amount of water may be added if necessary.

Application

Masking

Mask all areas where there is a risk of splashing and staining and where straight edges are required. Masking tape must be removed before the material has dried.

Filling holes and indentations

Mix 4 volumes of weber.cote Brush Coat and 1 volume of water to a paste. Use this mix to fill any holes or indentations in the surface. Scrape flush with the surface and leave to dry overnight.

Application Method

The surface should be dry when application starts.

  • Wet the brush and shake off access water.
  • Dip the brush in the mixture and brush the wall liberally. Make sure to fill the small holes and indentations.
  • Coat the entire wall in one operation to avoid dry joints. Do not stop and start. Do not patch.
  • Leave overnight to cure.

Note: A second coat may be applied if required and should be cured in the same way.

Coverage

Coverage is approximately 7m2 to 10m2 per 20 kg bag.

Curing

Wet the coated walls 3 times during the next day using clean water.

Packaging, Health & Safety

Packaging

weber.cote Brush Coat is supplied in 20 kg bags.

Safety Instructions

Contains cement, which is alkaline when wet and can cause skin irritation. Use eye protection and gloves and avoid prolonged skin contact. Avoid inhalation of dust. Wash skin contamination away with warm soapy water. Remove splashes to the eyes by prolonged irrigation and consult a doctor. Do not ingest.