weber.adBond-It, WB183 

Use Bond-it to replace the water in the mix when applying tile adhesive tile grouts in the following areas :

• Permanently wet areas including abbatoirs and butcheries

• Heavy traffic areas including hospitals, dairies and restaurants

• Intermittently wet and dry conditions

• Kitchens, bathrooms and showers

• Smooth trowelled wall and ­ floor areas

• Cold rooms and walls where extreme temperature changes occur.

Note: Tile adhesives and tile grouts will dry a shade darker when mixed with Bond-it. The drying time will be increased by approximately12 hours.

• Exceptional and consistent quality
• Suitable for areas that will be dry or intermittently wet
• Strengthening agent
• Water-resistant properties
• Limited ­exibility to accommodate some movement
• Suitable for interior and exterior use

Coverage is subject to the mixing requirements of the material
Bond-it is mixed with.

Refer to the instructions of the product Bond-it is mixed with. Ensure that all surfaces are clean, dry, sound and free from dust, grease or any contamination that could impair bonding. Organic growth must be removed and the spores killed using an effective fungicide.

Bond-it is supplied ready for use. Do not add water.

Refer to the instructions of the product Bond-it is mixed with.

No curing is required.

When stored, unopened in a dry place at temperatures above 5^oC, shelf life is 12 months from date of manufacture. Replace the lid after use.

Use eye protection and gloves and avoid prolonged skin contact. Wash skin contamination away with warm soapy water. Remove splashes to the eyes by prolonged irrigation and consult a doctor. Do not ingest.

We agree that Weber products meet the product specifications and will be free from any defect. Any guarantee with regard to the performance of Weber products will be subject to the professional and practical application of Weber products in accordance with our instructions and specifications.

However, we have no in­fluence over specific site conditions and therefore, if in doubt, the user should first carry out sufficient tests to ensure that the product is suitable. In special cases, obtain advice.

Should our product prove defective, we undertake to replace any defective material. This guarantee will fall away in the event of Weber products being contaminated by the addition of sand, cement or substance other than recommended by us.

Weber has a team of experienced advisors available to provide technical support.

Technical helpline : 0860 27 28 29 or visit www.weber-tylon.co.za

77 Ostend Road, Germiston South, Johannesburg Tel.: +27 11 345-5300  Fax: +27 11 345-5301 Sales : 0860 27 28 29 or visit www.weber-tylon.co.za